Synthesizers · Studio
Why Malaysian Producers Are Trading VSTs for True Analog: Inside the Sequential Sound
By Khai · Music Bliss | 19 November 2026 | 10 min read

It is two in the morning and the session has forty tracks in it. Eleven of them are software instruments. You have been auditioning presets for an hour, you have three versions of the same pad, and you have a growing suspicion that the reason nothing is landing is not that you have the wrong preset — it is that you have spent the entire evening looking at a screen and clicking a mouse, and at no point have you actually played anything.
That feeling is what sends producers towards hardware, and it is worth being honest about why. This article is not going to tell you that analogue instruments sound better than software, because that is not a claim anyone can properly support and you would be right to distrust it. What it will do is explain what genuinely differs — in the architecture, in the workflow, and in one specific design decision Sequential made that says more about "analogue character" than any amount of marketing language — and then look closely at the two instruments that best represent it: the Sequential Oberheim OB-6 and the Sequential Prophet-10.
Earlier in the journey? Start with Your First Journey To Electronic Music.

What Changes When The Instrument Is A Physical Object
Start with the part that has nothing to do with sound.
Both of these synthesisers are knob-per-function instruments. Every significant parameter has its own physical control, permanently in the same place, doing one job. There is no menu. There is no page. There is no submenu three levels down where the envelope release lives.
The consequence is that after a few weeks you stop looking. Your hand goes to the filter cutoff because that is where the filter cutoff is, in the same way a guitarist finds the tone control without checking. You are adjusting the sound while listening to it rather than while reading about it, and that is a genuinely different creative act. Ideas survive that would otherwise die during the twenty seconds it took you to find the right window.
The second thing is subtraction. A plugin arrives with several hundred presets and an endless browser. These instruments have a panel, and what is on the panel is what there is. You cannot audition your way out of a decision. You have to build the sound, and building it teaches you what the controls do in a way that scrolling never will.
None of this is measurable and none of it is on a spec sheet. Ask anyone who has moved from software to a hands-on instrument what changed, though, and this is what they describe first — not the sound, the working.

Why Six Voices Is A Feature
A software instrument has effectively unlimited polyphony. Your computer will happily give you sixty-four voices across eleven instances, and it is very easy to end up with an arrangement where everything is layered onto everything else and the whole thing has turned to soup.
The OB-6 gives you six voices. Not six per instance — six, total, because there are six physical sets of oscillators and filters inside it. Play a seventh note and something has to give.
That sounds like a limitation and functions as a discipline. You cannot stack indefinitely, so you make decisions: is this a five-note voicing or a three-note voicing with the bass playing the root? Does this pad need to be a pad, or does the arrangement need space there? Producers who work with hardware polysynths consistently report that their arrangements got tidier, and the reason is not mystical. The instrument stopped letting them avoid the question.
The Prophet-10 doubles it to ten voices, which is generous by any standard and is the point of the instrument. Worth being accurate, though: ten voices means ten notes. Two-handed chords with a sustain pedal down can still exceed it. What ten voices really buys is not "never run out" — it is headroom to play properly, and the ability to split or layer the instrument in two, which we will come to.
Monophonic, polyphonic, paraphonic? See Every Types Of Synthesizers You Should Know (Part 1).

What "Analogue Character" Actually Means
Here is the part that makes the argument honest, and it comes from Sequential's own documentation rather than from us.
The Prophet-10 has a control on the front panel called the Vintage knob. Sequential describe it as recreating the characteristics of different Prophet-5 revisions "by varying the behavior of oscillators, envelopes, amplifiers, and other components." Turn it to 4 and you get the modern, stable instrument. Turn it towards 1 and you get the behaviour of the original Rev1 — which Sequential themselves describe as "the rarest and most temperamental of all Prophet-5s." Among the things it varies are slight timing differences between the voices.
Read that again, because it is the whole story. The flagship analogue polysynth ships with a knob whose purpose is to make the instrument less consistent.
That tells you what people actually mean by analogue character. It is not warmth, and it is not a frequency response. It is controlled imperfection — the fact that in a six or ten voice analogue instrument, every voice is its own physical circuit with its own component tolerances, so a chord is six or ten slightly different instruments playing together rather than one sound copied identically. The oscillators are not in perfect agreement. The envelopes do not fire at precisely the same instant. Nothing is badly wrong; everything is very slightly different.
Software can model this, and good software does. But it has to be added deliberately, because maths is perfect by default. The reason Sequential built a knob for it is that the imperfection is the point, and a Rev4 built to modern tolerances was, if anything, too clean.
If you have ever layered a software pad six times and wondered why it sounded like one big sound rather than six, this is the mechanism you were missing.

More on the trade-off: Hardware Synthesizers vs Software Synthesizers.

The OB-6, And The Filter It Is Built Around
The Sequential Oberheim OB-6 is a six-voice analogue synthesiser designed by Dave Smith with Tom Oberheim, and it exists to put Oberheim's sound into a modern instrument. Two discrete voltage-controlled oscillators per voice plus a sub-oscillator, continuously variable wave shapes, hard sync, and a full analogue signal path.
The thing that defines it is the filter, and it is worth understanding properly because it is not the filter most synthesisers have.
Most classic polysynths use a four-pole low-pass filter — it removes frequencies above the cutoff point, steeply, and that is its only mode. It is the sound of a great many records and there is nothing wrong with it.
The OB-6 uses a two-pole state-variable filter modelled on Tom Oberheim's original SEM circuit, and a state-variable design can operate as low-pass, high-pass, band-pass or notch. Two poles means a gentler slope than a four-pole design — it removes less, less aggressively, above the cutoff.
What that changes in practice is the character. A gentler slope leaves more upper harmonic content in the sound, which is why OB-6 patches tend to stay present and open rather than closing down as you sweep the filter. The notch and high-pass modes are the ones producers reach for and cannot get from a conventional ladder filter — a notch pulls a band out of the middle of the sound, which is what gives that hollow, vocal, slightly phasey quality that runs through so much synth-pop, and a high-pass setting hollows the bottom out entirely and leaves you with something thin and glassy that sits above a mix instead of filling it.
This is why the OB-6 turns up where it does. For modern synth-pop, for R&B where the pad has to be lush without swallowing the vocal, and for cinematic swells where you want a chord to bloom and stay wide rather than closing in — the state-variable filter is doing work a low-pass filter simply cannot do.
New to filters and subtractive synthesis? Read Every Types Of Synthesizers You Should Know (Part 2).
On top of that sit dual digital effects (reverbs, delays including a bucket-brigade emulation, chorus, flanger, phaser and ring modulator), a 64-step polyphonic sequencer, an arpeggiator, and a four-octave semi-weighted keyboard with velocity and aftertouch.


The Prophet-10, And What Ten Voices Buys You
The Sequential Prophet-10 is the studio heavyweight, and it is a direct descendant of the instrument that more or less invented the programmable polysynth.
Two Curtis CEM 3340 oscillators per voice with simultaneously selectable wave shapes, a four-pole resonant low-pass filter per voice, Poly Mod routing the filter envelope and oscillator B to oscillator A's frequency and pulse width and to the filter cutoff, ADSR envelopes with velocity, and a five-octave semi-weighted Fatar keyboard with velocity and aftertouch.
Three things make it more than a Prophet-5 with extra voices.
The filter is switchable between two historical designs. You can run the Rev1/2 filter, based on the Dave Rossum-designed SSM chip, which Sequential describe as "rich in character but could be temperamental" — or the Rev3 Curtis filter, which they describe as offering "more stability and control." These are genuinely different circuits with different behaviour, particularly at high resonance, and having both in one instrument means you are not committing to one flavour of the same classic synth.
The Vintage knob, covered above, lets you decide how tightly the instrument holds itself together.
And it is bi-timbral, which is the feature that actually justifies ten voices. You can split the keyboard or layer two completely separate sounds, five voices each — a bass patch under your left hand and a lead under your right, or a pad and a plucked sound stacked into one enormous chord. That is the thing you cannot do on a five-voice instrument at all, and it is a large part of why producers who could afford either end up here.
Practically, ten voices means you can play with both hands, hold a chord, and add a melody on top without the earliest notes being cut off. For anyone whose writing starts at a keyboard rather than in a piano roll, that is the difference between an instrument that keeps up with you and one you have to arrange around.
Shop: Sequential Prophet-10

OB-6 Or Prophet-10?
They are not competing for the same job, which makes this easier than it looks.
Choose the OB-6 if what you want is character and movement. The state-variable filter is the reason to buy it, and if your music lives on textures that shift — synth-pop, R&B, electronic, anything where the pad is doing something rather than just sitting there — it will give you sounds the Prophet cannot. It is also the more immediate instrument to learn, with six voices and a smaller keyboard.
Choose the Prophet-10 if what you want is foundation and scale. Ten voices, bi-timbral splits and layers, two historical filter characters, and the classic four-pole sound that anchors a track rather than decorating it. If you play with both hands and write from the keyboard, this is the one.
And if you are agonising: the OB-6 is the more distinctive instrument, the Prophet-10 is the more versatile one. Most people who own both use the Prophet for the parts holding the song up and the OB-6 for the parts people remember.
Both also exist as desktop modules — the same synthesiser engine and the same controls without the keyboard. If you already have a MIDI controller you like, and your desk in a condo bedroom is already full, the module is the more sensible purchase by some margin, and it costs meaningfully less.
Shop the modules: OB-6 Module · Prophet-10 Module.

If You Want Smaller, Or More Hybrid
Two other Sequential instruments are worth knowing about, and both are order-in rather than on the shelf.
The Sequential Take 5 is the compact one: five voices, dual VCOs per voice, a four-pole resonant filter drawn from the Prophet-5 Rev4, 44 semi-weighted keys with aftertouch, and 256 patch locations. It is the most accessible way into a genuine analogue polysynth from this family, and for a producer whose main instrument is the computer and who wants one real synth on the desk, it is often the right answer rather than the compromise.
The Sequential Pro 3 is the different one, and it is worth being precise about it because it is not a purely analogue instrument. It runs two analogue VCOs alongside one digital wavetable oscillator — 32 wavetables of 16 waves each with morphing, plus classic shapes and a super saw. It offers three switchable filters: the Prophet-6 four-pole low-pass, a transistor ladder, and the OB-6 two-pole state-variable. It is monophonic with a three-voice paraphonic mode, and it carries a deep 16-track sequencer with per-step ratcheting.
That combination makes it the sound-design instrument of the group. If you want basses and leads with real weight, sequences that evolve, and digital textures that an all-analogue synth cannot produce, the Pro 3 does things neither of the polysynths can — and being able to audition the same patch through three different classic filter designs is an education in itself.
Shop The Gear at Music Bliss
100% authentic gear, expert product consultation, after-sales service and support, and nationwide delivery across Malaysia.
Polyphonic analogue synthesisers
- Sequential Oberheim OB-6 6-voice Polyphonic Analog Synthesizer
- Sequential Prophet-10 61-key Analog Synthesizer
Desktop modules — same engine, no keyboard
Compact and hybrid
- Sequential Take 5 Compact Polyphonic Analog Synthesizer
- Sequential Take 5 Polyphonic Desktop Synthesizer Module
- Sequential Pro 3 Multi-filter Mono Synth
- Sequential Pro 3 SE Special Edition
The wider Sequential and Oberheim range
Music Bliss showroom · Petaling Jaya
Come And Play One
There is very little point reading about a synthesiser. Ten minutes with your hands on an OB-6 will tell you more than this entire article, and you will know within about thirty seconds whether the state-variable filter is a sound you have been looking for or not.
So come in and play them. Bring headphones you know, bring a track you are working on if you want, and tell our team what you make and what your setup looks like now — and we will give you a straight answer about which one fits, whether the module makes more sense than the keyboard, and whether the honest recommendation is to spend the money on monitoring first.
Everyone on our floor makes music. You will not get a sales pitch. By Musicians, For Musicians.
About the author
Khai
Khai is part of the Music Bliss team, writing about recording, synthesizers and studio gear — and the tools on our showroom floor that get ideas finished.


