Warm Audio All-Analog Studio Re-Amper With Independent Preamp & Re-Amp Signal Paths

The Warm Audio Reamper is a creative routing hub that lets guitar amps, pedals, synths, and studio gear work together, with silent tube amp recording built in. Re-amp dry DAW signals with any of your favorite tube amplifiers. Add any studio gear to your guitar chain, or add any guitar effects to your typical studio chain - easily. Use the built-in power soak to record tube amps up to 50W (8Ω impedance) without engaging the speaker for silent tracking. Not limited to just guitar, add any synth modules to line-level sources as well and craft the ultimate experimental tones with any type of effects processors. 

SPECIFICATIONS

• Tech  Specs 
  PRODUCT DESCRIPTION & EXTERNAL SPECS
  -Dual-Channel Active Instrument Preamp & Re-Amp Device
  - Independent Instrument Preamp And Re-Amp Signal Paths
  - CineMag Transformer Isolation On Each Signal Path
  - Connect Instrument, Line-Level, & Speaker-Level Signals 
  - Compatible With Passive And Active Instruments, Keyboards, And Pedals
  - Speaker Input With Direct Through Or Built-In Power Soak For Silent Operation
  - Stepless Re-Amp Output Level Control For Attenuation Or Gain
  - Balanced Line-Level I/O On XLR And 1/4" Connections (No Phantom Power Required)
  
  
• COMPONENTS & INTERNAL SPECS
  - Custom CineMag USA Transformers On Each Signal Path (Inputs & Outputs)
  - Switchable JFET Discrete Or JFET Op-Amp Instrument Input Stage
  - Fully Active Circuitry With Ultra-Low-Noise Design
  - High-Quality Components Throughout Signal Path
  - Internal Universal AC Power Supply
  
  
• PERFORMANCE SPECS
  - Channels: 2
  - Maximum Instrument Input Level: +18 dBu (6 VRMS)
  - Instrument Input Impedance: Variable 120kΩ To 1MΩ
  - Re-Amp Output Level: Stepless Attenuation To Gain
  - Speaker Power Soak: 8 Ohms, 50 Watts Max
  - Balanced Line Output: True Line Level On XLR And 1/4"
  - Phase-Invert & Ground/Lift Per Channel
  - Power: 90–240V AC, 50–60 Hz
  
  
• Popular Uses
  - Run DAW tracks back through any tube amp or effects pedals
  - Cleanly mix/match any guitar and studio sources with or without analog vibe using the JFET / Op-Amp switch
  - Use the built-in power soak to record tube amps up to 50W (8Ω impedance) without engaging the speaker for silent tracking.
  - Easily add delays, reverbs, tremolos, or ring modulators to vocal chains, drum busses, and much more.
  - Run your guitar signal through studio-grade preamps, compressors, EQs & more to get the full impact of a pro studio signal chain on guitar recordings